Polylines don’t have to be just straight line segments – they can have arcs, too. At any time during the PLINE command, just type “A” at the command line, and you’re drawing arcs. The default direction is tangent to the last segment you drew, but you can specify the radius, direction, or a second point if you don’t like the default. When you’re done with arcs, “L” will get you back to straight lines.
skip to main |
skip to sidebar
About the blog
Welcome to Kate's CAD Tips!
I've been sending these tips out to my office once a week for about three years now, and decided to start the blog as a way to put them all in one place. Who knows, maybe they'll help somebody else out there too!
Some of the tips are pretty basic, but hey, we all had to start somewhere.
Most of the tips apply to AutoCAD 2004 & up -- I'll try to note if it's only available in later versions, but no promises. And ALL the tips apply to AutoCAD LT.
As always, if you have a tip you'd like to see featured, send it on in!
I've been sending these tips out to my office once a week for about three years now, and decided to start the blog as a way to put them all in one place. Who knows, maybe they'll help somebody else out there too!
Some of the tips are pretty basic, but hey, we all had to start somewhere.
Most of the tips apply to AutoCAD 2004 & up -- I'll try to note if it's only available in later versions, but no promises. And ALL the tips apply to AutoCAD LT.
As always, if you have a tip you'd like to see featured, send it on in!
No comments:
Post a Comment