To quickly create a radius at all the corners of a polyline, start the FILLET command and enter P for polyline. (Do not select an object before typing P.) Then select your polyline and it will fillet instantly. This is also the only way to fillet the "start" and "end" segments of a closed polyline without an error message.
skip to main |
skip to sidebar
About the blog
Welcome to Kate's CAD Tips!
I've been sending these tips out to my office once a week for about three years now, and decided to start the blog as a way to put them all in one place. Who knows, maybe they'll help somebody else out there too!
Some of the tips are pretty basic, but hey, we all had to start somewhere.
Most of the tips apply to AutoCAD 2004 & up -- I'll try to note if it's only available in later versions, but no promises. And ALL the tips apply to AutoCAD LT.
As always, if you have a tip you'd like to see featured, send it on in!
I've been sending these tips out to my office once a week for about three years now, and decided to start the blog as a way to put them all in one place. Who knows, maybe they'll help somebody else out there too!
Some of the tips are pretty basic, but hey, we all had to start somewhere.
Most of the tips apply to AutoCAD 2004 & up -- I'll try to note if it's only available in later versions, but no promises. And ALL the tips apply to AutoCAD LT.
As always, if you have a tip you'd like to see featured, send it on in!
No comments:
Post a Comment